MITCHDRYBOND GP

Cementitious, Polymer Modified General Purpose Tile Adhesive

MITCH DRYBOND GP a single component cementitious powder containing performance enhancing polymers, silica and lot of other additives. It’s ready to use only requires addition of water on site. MITCH DRYBOND GP is perfect for fixing ceramic tile, quarry tiles and similar materials. It provides strong adhesion to cement/sand screeds, to insitu/ pre-cast, concrete and brickwork. For external wall application use MITCH DRYBOND SP.

• MITCH DRYBOND GP can be used for tile on tile for cement tile only.
• MITCH DRYBOND GP can be used for new tiling in internal floor and walls.
• MITCH DRYBOND GP can be used for new tiling at external floor and roof.
• MITCH DRYBOND GP can be used for new tiling with ceramics and decorative cladding.
• MITCH DRYBOND GP can be used for new tiling at showers & wet processing areas, laboratories, hospitals, canteens, Tiling corridors, pavements etc.

• Thin Bed Tiling: Can be applied between 3 mm to 6 mm
• Easy to Use: Just add water on site
• Pre-packed: Consistent Quality
• Dry Bonding: No need to moist the substrate and neither pre – soaking tiles required
• Water Resistant: Can be used on wet areas e.g. washrooms
• Slow Setting: Long pot life and slow setting time (Initial Setting @ 6 hours , Final Setting @ 7 hours)
• Tile Adjusting Limit: Tiles can be adjusted till 30 minutes after application
• Bond Strength: Very good bond strength up to 1.5 N/mm2